9. Technical Specifications
For Tower model at PF0.8
Tower model (with LCD display)
Capacity (VA) 6000VA 10000VA
Capacity (W) 4800W 8000W
Voltage (on battery) 208V, 220V, 230V, 240V +/-2% (Selectable Output Voltage)
Frequency
(on battery)
50 / 60 Hz +/-0.5%
Transfer Time 0 ms
Overload Recovery Auto transfer to UPS
High Efficiency mode
(AC to AC)
> 95 % > 97 %
UPS Design Technology On-Line / Fully digitized microprocessor controlled
Output Wave Form Sine wave
Harmonic distortion < 3% of T.H.D. at linear load
Crest Factor 3 : 1
Surge Protection IEC 61000-4-5 level 3
Overload Protection
106~120% for 30 seconds and
121~150% for 10 seconds
1106~120% for 30 seconds and
121~150% for 10 seconds
Short Circuit Protection UPS output cut off immediately or input fuse / circuit breaker protection
Visual Display
(LED model)
UPS on(green), line-mode(green), battery mode(yellow), bypass(yellow),
fault(red)
Visual Display
(LCD model)
Input / output voltage, input / output frequency, on-line mode, back up mode,
battery capacity, load level
Audible Alarm (Battery
back-up)
Beep every 5 sec
UPS Fault Continuous beeping sound and LCD display
Communication RS-232 Serial Port and USB
Type Sealed, maintenance-free lead acid batteries
DC Voltage (V) Battery
(Tower )
240V / 12V7AH
x 20
240V / 12V9AH
x 20
Typical Recharge Time
to 90% Full
4 hours
Management Self-test, adjustable battery transfer points and alarm settings
Battery Protection Cut off without draining any current when battery is low
Cold Start (DC start) YES
Back Up Time
(Tower model)
About 3~5min. Full load /
10~15 min. Half load
About 4~5min. Full load /
9~10 min. Half load
Input Inlet Hardwire
Receptacles Hardwire
Dimensions
W x D x H mm (inch)
W/O ISOTR
257 x 590 x 570
(10.1” x 23.2” x 22.4”)
257.4 x 642.4 x 585.2
(10.1” x 25.3” x 23.0”)
Net Weight
kg (lb) W/O ISOTR
86.0 (189.2) 95.5 (210.4)
Shipping Weight
kg (lb) W/O ISOTR
106.0 (233.2) 107.5 (236.8)
Operating Temperature 0~40
°
C / 32~104
°
F
Storage Temperature -20~50
°
C / -4~122
°
F
Altitude 2000 meters max
Audible Noise
(1 meter from surface)
60 dBA < 60 dBA
Relative Humidity 0 ~ 95% humidity, non-condensing
Safety CE
EMC (EMS / EMI) EN 62040-2, CISPR 22
EN 62040-2
EN 62040-2, CISPR 11