3-1
3
Matrix E7 Setup
This chapter contains instructions on setting up the Matrix E7 chassis.
Equipment needed:
• Phillips screwdriver
• Flat blade screwdriver
A Phillips screwdriver is needed to install the unit in a 48.26-centimeter (19-inch) equipment rack
and to install the cable management bar. A large flat blade screwdriver is needed to secure the
power supplies and to remove and reinstall the fan tray. Refer to Chapter 2 for the guidelines that
must be followed to install the Matrix E7 chassis.
ELECTRICAL HAZARD: Only qualified personnel should install or service this unit.
To Next Page
Loading...
