Entrust Sigma Series User Manual

Cleaning Guide
528293-001_B 9
Prepare the Printer for Use
Do the following aer the cleaning cycle completes.
1. Unlock the printer locks.
2. Replace the cards in the input hopper of a single-hopper printer and
close and lock the hopper.
3. Install a new cleaning roller on the ribbon cartridge. Refer to “Replace
the Cleaning Roller” on page 10.
4. Load the print ribbon into the printer.
5. Close the printer cover. Press down on the ridges on the front of the
cover to latch it completely.
6. Lock the printer.
7. Discard the used cleaning card and cleaning roller
Printer best pracces recommend that you clean the printer every
500 cards processed. If enabled, the message “Cleaning required”
displays on the printer LCD panel when the congured cleaning
count is reached. Clean the printer to connue prinng.
An administrator can change the congured cleaning count using
the Printer Dashboard.

Entrust Sigma Series Specifications

General

Brand	Entrust
Model	Sigma Series
Category	Printer
Language	English