3 Ethernet Link: This LED will be ON when there is an Ethernet Link.
4 Ethernet Activity: This LED blinks when there is activity on the Ethernet
network.
NMU configuration
NMU (Node Management Utility) is the free Windows and OSX application
used to manage compatible ENTTEC DMX over Ethernet nodes.
NMU bypasses all your TCP/IP settings allowing you to reconfigure nodes in a
plug and play fashion, how ever they are configured.
NMU V1.34 supports the ODE starting with the V1.0 firmware.
To employ the NMU, follow this set of instructions:
1. If you have not already done so, install the program from the included
CD, or download and install this application from the Enttec website
http://www.enttec.com/nmu(nodemanagement)
2. Ensure that your ODE is hooked up physically by Ethernet cable to the
same physical network as the computer on which you will run the NMU.
This can be done directly to the port on your computer or through a
switch.. When you plan to use multiple ODEs you will need to use a
switch.
3. Start the application.
4. Press the Discovery button.
ODE User Manual 10
To Next Page
Need help?
General
