Limitations
As the ODE is reliant on Ethernet, if you are using an existing computer
network and sharing the traffic between your lighting control system and other
functions, you may increase your exposure to potential delays in data
propagation, or a drop in the update rate. Specific strategies for better
implementing such large networks can be planned in consultation with Enttec
engineers if your application's scope warrants it.
Basic Concept
While it has tremendous flexibility, right out of the box the ODE is factory
configured to be a DMX OUTPUT device, running on Art-Net Universe 0,0. It
can be either output or input, however, and can use any possible universe in
Art-Net or ESP modes. It has configurable IP address as well. Use the free
utility program, Node Management Utility, to change configurations.
Connector pin out
DMX OUT:
Pin 1: Ground
Pin 2: Data -
Pin 3: Data +
Pin 4: NC
Pin 5: NC
DMX IN :
Pin 1: Ground
Pin 2: Data -
Pin 3: Data +
Pin 4: NC
Pin 5: NC
ODE User Manual 8
To Next Page
Loading...
Need help?
General
