Enttec Open DMX Ethernet User Manual

Glossary
ACN: Advanced Control Network.
Art-Net: Artistic License network protocol. This is the Artistic License
DMX over Ethernet protocol.
Dimmer: One discretely controlled device or parameter of a device out of
512 possible in the DMX512 protocol. Sometimes also referred
to as “Address”, “DMX Channel” or “Output Channel”
DHCP: Dynamic Host Configuration Protocol.
ESP: Enttec Show Protocol. This is the Enttec DMX over Ethernet
protocol.
HTP: Highest Takes Precedence.
IP: Internet Protocol.
LTP: Latest or Lowest Takes Precedence (Context usually informs
which one is applicable.)
PC: Personal Computer.
RDM: Remote Device Management.
Stream: A DMX512 over Ethernet Universe coming into or leaving the
ODE
Universe: 512 addresses or slots of control information as conveyed
by DMX512 protocol. As a lighting system may have more than
512 discrete things to control, multiple universes may be
required. When this is the case, the Universe number will be
expressed in 0-255 form for ESP or 0-15 subnet and 0-15
universe # for Art-Net.
ODE User Manual 6

Enttec Open DMX Ethernet Specifications

General

Brand	Enttec
Model	Open DMX Ethernet
Category	Controller
Language	English

Summary

Contacting ENTTEC

Warranty

Glossary

Introduction

Features

Limitations

Basic Concept

Connector Pin Out

DMX OUT Pin Configuration

Specifies the pin assignments for the DMX output connector including Ground and Data pins.

DMX IN Pin Configuration

Specifies the pin assignments for the DMX input connector including Ground and Data pins.

Getting Started

Default DMX Port and Ethernet Channels

Outlines the default settings for DMX output and Ethernet Universe 0,0.

LED Status Indicators

Explains the meaning of the four status LEDs on the ODE device.

NMU Configuration

Updating the Application Firmware

Emergency Firmware Update

Appendix 1: FCC Declaration

Appendix 2: CE Compliance