JOHNSON CONTROLS
5
FORM ET130.13-NOM3 (708)
INSPECTION
Upon receipt of equipment, carefully check all items
against the bill of lading to ensure that all equipment has
been received (including shipped loose items). Note any
discrepancy on the bill of lading before signing. Note
that “ship loose” items may be included with the base
unit or shipped (bulk) on a separate pallet.
Inspect all equipment for any signs of damage caused
during transit. On equipment with electric heat, make
sure to check the coil fi ns and/or make sure that the
resistance heat coils are not damaged. Note any
visual damage on the bill of lading before signing.
Immediately report all visual and concealed damage
to the carrier and fi le a claim with the carrier.
Locate the model number on the nameplate and check
that the correct equipment has been received. Verify
that all options have been included, such as controls,
fi lters, heating coils, etc. Also check that equipment
voltage agrees with the building parameters. If a
discrepancy is discovered between what was ordered and
received, contact your local Enviro -Tec representative
immediately.
Do not use fl ow sensor, connecting
tubes, coil stubouts or damper shaft
as a handle when lifting or moving
equipment as damage may occur.
Do not handle by equipment’s heat-
ing elements, as permanent damage
will occur.
Check assembly and component
weights to be sure that the rigging
equipment can handle them safely.
Note; also check the centers of gravity
and any specifi c rigging instructions.
Check for adequate ventilation so
fumes do not migrate through ductwork
to occupied spaces when welding or
cutting around the equipment.
Do not work on damper until associ-
ated actuator is disconnected.
Never pressurize equipment above
specifi ed test pressure.
Protect adjacent fl ammable materials
when brazing. Use fl ame and heat
protection barriers where need. Have
a fi re extinguisher at hand and ready
for immediate use.
STORAGE
If equipment is to be stored prior to installation, observe
the following precautions:
1. Choose a dry storage site that is reasonably level
and sturdy to prevent undue stress or permanent
damage to the equipment. Set equipment off
ground if in moisture prone areas.
2. Cover entire equipment with protective tarp or
moisture proof cover. Extend cover under equip-
ment if stored on ground. Secure cover with
adequate tie downs. Be sure that piping connec-
tions have protective shipping caps installed.
3. Do not stack equipment any higher than how
it was shipped. If equipment has been unpack-
aged since receipt from the factory, do not stack
without equivalent support between units as was
supplied from the factory.
PRE-INSTALLATION INSPECTION
Do not use fl ow sensor, connecting
tubes, coil stubouts or damper shaft
as a handle when lifting or moving
equipment as damage may occur.
Do not handle by equipment’s heat-
ing elements, as permanent damage
will occur.
To Next Page
Loading...
Need help?
General