To Next Page

To Previous Page

zeRo cLeaRance (zc) fiRepLace instaLLation:

The metal oor of the ZC solid fuel rebox can be removed to allow the installation of the insert. THE

CLEARANCE TO COMBUSTIBLE MATERIAL UNDER THE INSERT IS 1/2” (13 mm). YOU MUST RAISE THE

INSERT A MINIMUM OF 1/2” (13 mm) IF THE UNIT IS TO BE INSTALLED ON COMBUSTIBLE MATERIAL.

The optional Base Shelf and Riser are recommended to ll the space under the unit once raised. The

sidewalls and top structure of the solid fuel rebox cannot be altered with the exception of: removal of

dampers, removal of smoke shelf or bafe, removal of ember catches, removal of log grate, removal of

viewing screen/curtain, and removal of doors. THE ORIGINAL FIREPLACE MAY NEVER BE RETURNED TO

SOLID FUEL USE IN THIS CONDITION.

IMPORTANT: If the factory-built replace has no gas access hole(s) provided, an access hole of 1.5 inch

(37.5 mm) or less may be drilled through the lower sides or bottom of the rebox in a proper workmanship

like manner. This access hole must be plugged with non-combustible insulation after the gas supply line

has been installed. Cutting any sheet-metal parts of the replace, in which the gas replace insert is to

be installed, except as tested for the oor is prohibited.

The included label plate shown below must be permanently attached inside the cavity of the replace

in a visible location.

WARNING: This fireplace has been converted

for the use with a gas fireplace insert only and

cannot be used for burning wood or solid

fuels unless all original parts have been

replaced, and the fireplace re-approved by the

authority having jurisdiction.

C-11168

Figure 32: Fireplace Altered Plate.

Initial Installation

QUALIFIED INSTALLERS ONLY

The replace must be electrically connected and grounded in accordance with local codes or, in the

absence of local codes, with the current CSA C22.1 Canadian Electrical Code Part 1, Safety Standards For

Electrical Installations, or The National Electrical Code ANSI / NFPA 70 in the US.

WARNING: The electrical grounding instructions must be followed. The fan kit is equipped with a three-

prong (grounding) plug for your protection against shock hazard, and should be plugged directly into a

properly grounded three-prong outlet. DO NOT cut or remove the grounding prong from this plug.

CAUTION: When servicing controls, label all wires prior to disconnection. Wiring errors can cause

improper and dangerous operation. Verify proper operation after servicing.

If any of the original wire as supplied with the appliance must be replaced, it must be replaced with 18

AWG wire with a temperature rating of 105°C

eLectRicaL RequiRements:

Enviro Q1C User Manual

Other manuals for Enviro Q1C