9
AlcoQuant® 6020 – Breathalyser – Operating Instructions
6
66
6 How to measure in the active operating mode
How to measure in the active operating modeHow to measure in the active operating mode
How to measure in the active operating mode
Measuring in the active device operating mode serves to determine the precise alcohol level
in the expired air. It is ensured that for this process only deep lung air is delivered to the
sensor. This is necessary because the only clear correlation is between the alcohol content of
deep lung air and the blood alcohol level.
6.1
6.16.1
6.1 How to switch on the
How to switch on the How to switch on the
How to switch on the AlcoQuant® 6020
AlcoQuant® 6020AlcoQuant® 6020
AlcoQuant® 6020
The “ON/OFF” key must be pressed for approximately 1 sec. to switch on the AlcoQuant®
6020 The device switches on after one second and automatically performs a self test of the
internal functions and components. During the self test phase the device version and the
software version (Rev. x.x0) appear on the display for about 2 seconds:
ENVITEC
AlcoQuant
6020
Rev. x.x0
Display for about 2 seconds: the device self test is carried out and the next calibration date is
displayed. All three LEDs light up briefly.
Display after about 3 seconds: The device is now ready to start measuring (green LED
blinking at an interval of 1.5 seconds).
To Next Page
Loading...