EPC Inverta Series User Manual

Three Phase Output (DC to AC) Inverter
Users Manual
Ver1.2 PAGE :
15
ENGLISH
Alarm and warning messages are displayed timely on the LCD display. Audible alarm is also
provided at the mean time.
Possible alarm and warning messages are listed below.
Message
Meaning of the message
DC LOW
Indicates that the inverter input voltage is lower than the adjustable DC
LOW value. System continues to operate.
DC HIGH
Indicates that the inverter input voltage is higher than the adjustable DC
HIGH value. System continues to operate. In this case, the equipment will
stop generating DC to prevent any damage to batteries or load.
DC TOO LOW
Indicates that the inverter input voltage is lower than the adjustable DC TOO
LOW value. In this case, the equipment will stop generating AC to prevent
any damage to the input source, possibly batteries. (battery deep discharge
cutoff)
OVER TEMPERATURE
Indicates that the inverter bridge temperature has exceeded limits. The
equipment will stop generating AC.
IGBT / IPM FAULT
Indicates that the current of IGBT or IPM transistor of 3 phase inverter
bridge, has exceeded the limits. To protect the IGBT / IPM, the equipment
will stop generating AC.
MEMORY ERROR
Indicates, that the DSP control unit can not load the saved parameters
properly. In this case, the system will return to factory set values. Until this
alarm is resetted via the LCD panel, the equipment does not generate AC.
EARTH FAULT
Indicates there is a leakage current from any of the DC inputs to ground.
(OPS-02)
BREAKER OPEN
Indicates that one of the input or output circuit breakers are open. (Option
depending on user requirement)
FAN FAILURE
Indicates the failure of the cooling fan. (Option depending on user
requirement)
FUSE FAILURE
Indicates that one or more of the semiconducter rapid fuses has blown.
(Option depending on user requirement)
DOOR OPEN
Indicates that the enclouse door is opened. Used to inform the remote site, in
case there is maintenance on the inverter. (Option depending on user
requirement)
HARDWARE BLOCK
This alarm indicates that the “hardware block” function is active. Hardware
block is active, when a switch for hardware block is provided to the user and
if this switch is in OFF position. This alarm inhibits the operation of the
equipment.

EPC Inverta Series Specifications

General

Brand	EPC
Model	Inverta Series
Category	Inverter
Language	English