Three Phase Output (DC to AC) Inverter
Users Manual
Ver1.2 PAGE :
Permission
Setup
This menu mainly contain items about electrical settings. (Charge voltages,
alarm voltages, charge mode, …etc.)
DC Low
DC High
DC Too Low
Calibration
This menu block allows the user to fine tune the measured values of the
inverter, without any intervention to the electronic hardware of the
equipment. Using this menu only by authorized personnel is recommended.
Output Voltage U
Output Voltage V
Output Voltage W
Output Current U
Output Current V
Output Current W
DC Bus Voltage
DC Bus Current
About
Items in this submenu shows software versions and nominal values of the
device.
DSP Version
Shows the DSP software version placed on the control board of the device.
uC Version
Shows the microcontroller software version placed on the control board of
the device.
V Nominal (V)
Shows the nominal voltage (nameplate value) of the device.
To Next Page
Loading...
General