Epever EPIPDB-COM-10 - Page 5

3
the LED according to the following information, and then press the button
for 5 seconds until the number flashes. And then, choose one number you
need and leave it, and the number will be saved.
1. 1
st
LED is for the battery type setting.
1
st
LED
Battery type
1
Sealed battery
2
Gel battery
3
Flooded battery
2. 2
nd
LED is for the charging priority setting. Set the percentage for
battery #1, and the controller will automatically calculate the rest
percentage for battery #2.
2
nd
LED
Battery #1
charging percentage
Battery # 2
Charging percentage
0
0%
100%
1
10%
90%
2
20%
80%
3
30%
70%
4
40%
60%
5
50%
50%
6
60%
40%
7
70%
30%
8
80%
20%
9
90%(pre-set)
10%
Note: During the normal charging process, the controller charges the
battery per the set percentage. If one battery is fully charged (such as
battery #1), more charge current will be diverted to the other battery
(battery #2). The controller automatically returns to the setting percentage
when battery #1 is low voltage.
When the controller detects only one battery, all the charging current will go