Epever EPIPDB-COM-10 - Troubleshooting; Technical Information

4
to this battery automatically.
3. 3
rd
LED is for the charging frequency setting.
3
rd
LED
PWM charging frequency
0
25Hz(pre-set)
1
50Hz
2
100Hz
3. Troubleshooting
No.
LED Status
Troubleshooting
1
LED blinking
Short circuit. Please check whether the PV
and battery connection is correct.
2
LED slowly
flashing
Fully charged
3
LED ON
In charging
4
LED frequent
flashing
No charging or any battery is detected.
5
LED OFF
No battery or system over voltage.
4. Technical information
Model
EPIPDB-COM-10
EPIPDB-COM-20
Nominal system voltage
12/24VDC Auto
Rated charge current
10A
20A
Battery Type
Sealed; Gel; Flooded
Equalize charging voltage
Sealed: 14.6V; Gel: No; Flooded: 14.8V
Boost charging voltage
Sealed: 14.4V; Gel: 14.2V; Flooded: 14.6V
Float charging voltage
Sealed/Gel/Flooded: 13.8V
Maximum solar voltage
30V(12V System); 55V(24V System)