3
Before using the machine, read the operator’s
instructions carefully and then put them in a
safe place for future reference.
It can be dangerous to use the machine if the
care and maintenance instructions are not
followed carefully.
Electricity.
Emergency STOP.
Risk of crushing.
Always replace damaged or illegible signs�
Safety instructions
• Before using the machine, read through the operator’s instruc-
tions carefully.
• Important safety information is given at various points in these
instructions.
• Special attention must be paid to the safety information con
-
tained in frames and accompanied by a warning symbol (triangle)
and a “signal word“, as shown below:
Indicates an immediate risk that WILL result in serious injury
or death if the warning is not observed.
DANGER
Indicates hazards or hazardous procedures which COULD
result in serious injury or death if the warning is not observed.
WARNING
• Indicates hazards or hazardous procedures which COULD
result in injury or damage to equipment if the caution is not
observed.
• Use approved spare parts only. Any damage or malfunction that
can be attributed to the use of unauthorized spare parts is not cov-
ered by the machine warranty and invalidates product liability.
CAUTION
Also observe the following general safety
instructions:
• Make sure that there are no other personnel close to the grind-
ing machine while grinding is in progress.
• Always wear goggles, protective clothing, steel toe safety shoes,
gloves and hearing protection during grinding and handling of
grinding bits. Any local regulations must also be observed.
• Wear an approved dust mask or arrange an effective dust-extrac-
tion system. This is especially important when grinding indoors.
• The machine must not be used for any purpose other than that
for which it is intended. See “Applications“.
• The machine must not be modified without the permission of the
manufacturer. Modifications not approved by Epiroc can incur the
risk of serious injury to yourself and others.
• Before intervening in the air or electrical systems, make sure
there is no pressure in the air system and that the electrical sys
-
tem is shut down.
• Beware of the risk of fire and explosion that could be initiated by
sparks from the grinding work.
• Before using the machine, visually check the hoses and electric
wiring for any damage. If any visible damage is detected, replace
before using machine.
• If lifting equipment is used, make sure it’s approved for its
purpose.
• The splash guards supplied together with the machine must be
used during grinding.
To Next Page
Loading...
