Safety and operating instructions
© Construction Tools PC AB | 9800 0908 01 | 2023-05-12
Original Instructions
9
ate high velocity projectiles that can cause bodily injury.
In addition, objects falling from a height can cause bodily
injury. To reduce risks:
u Close off the working area.
u Before starting, make sure that no persons are in the
danger area, 20 meters both horizontally and verti-
cally from the hydraulic breaker.
u Immediately switch off the hydraulic breaker when
persons are present in the danger area.
u Press the working tool against the working surface
before you start.
u Never operate unless the working tool is retained in
the hydraulic breaker with a proper tool retainer.
WARNING Noise hazard
High noise levels can cause permanent and disabling
hearing loss and other problems such as tinnitus (ring-
ing, buzzing, whistling, or humming in the ears). To re-
duce risks and prevent an unnecessary increase in noise
levels:
u Risk assessment of these hazards and implementa-
tion of appropriate controls is essential.
u Operate and maintain the machine as recommended
in these instructions.
u Select, maintain and replace the working tool as rec-
ommended in these instructions.
u If the machine has a silencer, check that it is in place
and in good working condition.
u Always use hearing protection.
u Use damping material to prevent work pieces from
'ringing'.
2.10 Maintenance, precautions
WARNING Involuntary start
An involuntary start of the hydraulic breaker can lead to
severe injuries.
u Follow the instructions in the carrier manual to pre-
vent involuntary start of the hydraulic breaker.
u Installation of a start circuit on the hydraulic breaker
must be made in a way that avoids any unintentional
starts.
u A foot pedal on the carrier must be equipped with a
protection cover.
WARNING Hydraulic system under high pressure
Maintenance work on a hydraulic breaker under pres-
sure can lead to severe injuries. Connections can loosen
suddenly, parts can suddenly move and hydraulic oil can
be ejected.
u Depressurise the hydraulic system before performing
maintenance on the hydraulic breaker or the carrier.
WARNING Machine modification
Any machine modification may result in bodily injuries to
yourself or others.
u Never modify the machine. Modified machines are
not covered by warranty or product liability.
u Always use approved original parts, tools, and ac-
cessories.
u Change damaged parts immediately.
u Replace worn components in good time.
WARNING Hot working tool
The tip of the working tool gets very hot during opera-
tion. Touching it may lead to burns.
u Never touch the hot working tool.
u If you have to carry out any activities, wait for the
working tool to cool down first.
WARNING Working tool hazards
Accidental engagement of the start and stop device dur-
ing maintenance or installation can cause serious in-
juries, when the power source is connected.
u Never inspect, clean, install, or remove the working
tool while the power source is connected.
2.11 Storage, precautions
WARNING Heavy hydraulic breaker and working
tool
The hydraulic breaker and the working tool are heavy
equipment. If the breaker or working tool topple over or
fall down from where they are stored, it can result in ma-
terial damage and personal injury.
u Store the hydraulic breaker and the working tool so
that falling or rolling down is prevented.
2.12 Environmental Product
Compliance - Reach Declaration
Presence and name of substances in the products that is
included in EU Reach Candidate List of Substances of
Very High Concern are set out in the relevant Spare
Parts Catalog of each product.
To Next Page
Loading...
Need help?
General
