Jumper Settings for Main Board
1. Compact Flash Master/Slave Setting ◎ Factory Default Setting
Function JP1 (SHORT)
Master
◎1-2
Slave NC
2. ACPI Mode Setting
Function JP3 (SHORT)
Disable
◎1-2
Enable NC
3. I-Button Setting
Function JP4 (SHORT)
Use I-Button NC
No I-Button
◎1-2 3-4
4. CMOS Operation Mode Setting
Function JP5 (SHORT)
CMOS Normal
◎NC
CMOS Reset 1-2
To clear the CMOS:
1) Remove AC power from the unit.
2) Open the cabinet.
3) Change the JP5 jumper setting from N/C to 1-2.
4) Wait 1 minute.
5) Change the JP5 jumper setting back to N/C.
6) Close the cabinet.
7) Apply AC power and continue.
5. Power Mode Setting
Function JP9 (SHORT)
ATX
◎NC
AT 1-2
To Next Page
Loading...