Page 8
enclosure, ventilation is highly recommended.
WARNING: Risk of explosion! Never install the eTracer in a sealed
enclose with flooded batteries! Do not install in a confined area where
battery gas can accumulate.
Step 1: Choose Mounting Location
Locate the eTracer on a vertical surface protected from direct sun, high temperature,
and water.
Step 2: Check for Clearance
Place the eTracer in the location where it will be mounted. Verify that there is
sufficient room to run wires and that there is sufficient room above and below the
controller for air flow.
Figure 3-1 Mounting and cooling
To Next Page
Loading...
