Item Settings
AUX Init* -
Buffer Size* Normal, Maximum, Minimum
* Available only when On is selected as the AUX I/F setting.
AUX I/F
Allows you to activate or deactivate the AUX interface when an optional interface card is installed.
Buffer Size
Determines the amount of memory to be used for receiving data and printing data. If Maximum is
selected, more memory is allocated for receiving data. If Minimum is selected, more memory is
allocated for printing data.
Note:
❏ To activate Buffer Size settings, you must turn off the printer for more than five seconds then
turn it back on. Or, you can perform a Reset All operation, as explained in “Reset Menu” in the
User’s Guide.
❏ Resetting the printer erases all print jobs. Make sure the Ready light is not flashing when you
reset the printer.
Setting an IP Address on the Printer’s Control Panel (Large Format
Inkjet Printers)
After connecting the printer to the network, you need to set the IP address for the network interface.
To set the IP address, subnet mask, and default gateway from the control panel, follow the steps
below.
1. Turn on your printer.
2. Press the Right button on the printer’s control panel once to display MENU.
3. Press the Down button until NETWORK SETUP appears. Then press the Right button.
4. Select NETWORK SETUP, then press the Right button.
EPSON Network Guide
Tips for Administrator 126
To Next Page
Loading...
