Note:
❏ Announce the share name to your clients so that they know the share name of the printer
they want to use.
❏ If the Add Printer wizard prompts you to select either Keep existing driver or Replace
existing driver, be sure to select the Replace existing driver radio button.
8. Click Finish and follow the on-screen instructions to complete the setup.
Using the NET USE command
If you are running Windows Vista/XP/Server 2008/Server 2003/2000/NT 4.0 and using NetBIOS
to connect to the device, we recommend that you use the NET USE command, as follows:
1. Check that the following services are installed.
Right-click the Network Neighborhood icon on the desktop and select Properties. Click the
Services tab and check that Server or Workstation is listed.
2. If it is not installed, click Add.
3. Run the command prompt and enter the following command.
NET USE printer port: \\NetBIOS name of network interface\Device name of network interface
Selecting the port
1. Click Start, point to Settings, and then select Printers.
2. Right-click the printer icon and then select Properties.
3. Click the Ports tab and then select the port you have set with the NET USE command.
Macintosh
Follow the steps below to set a printer.
Note:
Make sure that the printer driver is installed on your Macintosh before following the steps below. See
the manual shipped with your printer for instruction on how to install the printer driver.
EPSON Network Guide
How To 69
To Next Page
Loading...
