5. Select the CD-ROM drive for Drives, and double-click the WINVISTA_XP_2K folder or the
WINVISTA_XP64 folder depending on your operating system. Click Open.
6. Click OK in the Install From Disk dialog box.
7. Select the model name of the device, and then click Next.
Note:
If the Add Printer wizard prompts you to select either Keep existing driver or Replace existing
driver, be sure to select the Replace existing driver radio button.
8. Click Finish and follow the on-screen instructions to complete the setup.
Using the NET USE command
If you are running Windows Vista/XP/Server 2008/Server 2003/2000/NT 4.0 and using NetBIOS
to connect to the device, we recommend that you use the NET USE command, as follows:
1. Click Start, click Control Panel, and then click View network status and tasks or
double-click Network and Sharing Center.
2. Click View Status, and then click the Properties button.
Note:
If the User Account Control screen appears, click the Continue button.
3. Check that Client for Microsoft Networks is installed. If it is not installed, click Install to
install it.
4. Run the command prompt and enter the following command.
NET USE printer port: \\NetBIOS name of network interface\Device name of network interface
Selecting the port
1. Click Start, click Control Panel, and then click Printers.
2. Right-click the printer icon and then select Properties.
3. Click the Ports tab and then select the port you have set with the NET USE command.
EPSON Network Guide
How To 47
To Next Page
Loading...
