Note for users of printers supporting NetWare queue-based printing:
❏ From any NetWare client, log in to the target NetWare server or NDS context with supervisor
privileges.
❏ You cannot create a print server, print queue, or printer with Web-based EpsonNet Config.
You must create these objects before using Web-based EpsonNet Config.
3. Click TCP/IP under Network on the Configuration menu to display the TCP/IP setting screen.
Note:
If you want to configure a protocol other than TCP/IP, configure the desired settings on
Configuration - Network screen.
4. Select a method for acquiring the IP address. When you select Auto, DHCP becomes available
and assigns an IP address automatically. If you want to set the IP address manually, select
Manual.
Note:
❏ The network administrator must check any changes made to the IP address settings.
❏ When Auto is selected, DHCP becomes available. To use the DHCP server, make sure it is
installed on your computer and correctly configured. See your operating system’s online help
for detailed instructions.
❏ If Set Using Automatic Private IP Addressing (APIPA) is enabled, a private IP address is
automatically assigned to the network interface even when there are no DHCP servers on
your system or your network.
❏ If the Dynamic DNS function is not supported, we recommend that you select Manual and
then enter an IP address. This is because if you select Auto, the IP address of the network
interface changes every time you turn on the printer so that you need to change the printer
port setting accordingly.
5. To assign an IP address manually, enter the IP address, the subnet mask, and the default
gateway. Be sure the IP address does not conflict with any other devices on the network.
Note:
If there is a server or a router functioning as a gateway, enter the IP address of the server or the
router for the gateway address. If there is no gateway, leave the default values there.
EPSON Network Guide
Network Software 95
To Next Page
Loading...
