EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 157
16. Remove the two screws that secure the SELECTOR, INK, ASSY. including the
damper, and remove the SELECTOR, INK, ASSY. upward from the CARRIAGE,
ASSY.
One C.B.P. 2.5 x 8 screw (2 ± 0.5 kgf.cm)
One C.B.S. 2.5 x 4 screw (2 ± 0.5 kgf.cm)
Figure 4-87. Removing the SELECTOR, INK, ASSY.
C A U T I O N
When installing the SELECTOR, INK, ASSY., make sure not to
mix up the C.B.P. 2.5 x 8 screw and the C.B.P. 2.5 x 4 screws as they
are similar to each other.
A D J U S T M E N T
R E Q U I R E D
Whenever the INK, SYSTEM, ASSY., is replaced,
the corresponding adjustments must be carried out.
See Chapter 5 "ADJUSTMENT" (p190).
C.B.P. 2.5x8
SELECTOR, INK, ASSY.
C.B.S. 2.5 x 4
To Next Page
Loading...
