EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 180
5. Disconnect the connector from the ASF SENSOR.
6. Release the FFC and cables listed below from the cable guides on the ASF,
ASSY.See Figure 4-123.
HARNESS, ENCODER, PF
HARNESS, DETECTOR, ASF
HARNESS, DETECTOR, RELEASE
7. Remove the screw that secures the grounding wire of the MOTOR ASSY., ASF
and remove the wire. See Figure 4-124.
One C.B.P. 3 x 8 screw (6 ± 1 kgf.cm)
Figure 4-123. Releasing the FFC and cables
Figure 4-124. Removing the screws from the MOTOR ASSY., ASF
Left side of the printer
cable guides
ASF SENSOR
HARNESS, ENCODER, PF
HARNESS, DETECTOR, ASF
HARNESS, DETECTOR, RELEASE
MOTOR ASSY., ASF
Put the screwdriver
through this hole.
Right side of the printer
grounding wire
(MOTOR ASSY., ASF)
C.B.P. 3x8
To Next Page
Loading...
