EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 181
8. Disconnect the relay connector of the MOTOR ASSY., ASF, and release the
cables from the two cable hooks. See Figure 4-41.
9. Remove the four screws that secure the ASF, ASSY. See Figure 4-125.
Two SHAFT, MOUNT, PLATEs: (9 ± 1 kgf.cm)
Two C.B.S. (P4). 3 x 8 screws: (9 ± 1 kgf.cm)
10. Lift up the ASF, ASSY., to disengage the two tabs from the main frame and
remove the ASF, ASSY. See Figure 4-125.
Figure 4-125. Removing the ASF, ASSY.
A D J U S T M E N T
R E Q U I R E D
Whenever the ASF, ASSY., is replaced,
the corresponding adjustments must be carried out.
See Chapter 5 "ADJUSTMENT" (p190).
SHAFT, MOUNT, PLATE
tab
SHAFT, MOUNT, PLATE
tab
main frame
ASF, ASSY.
Rear side
C.B.S. (P4). 3x8 C.B.S. (P4). 3x8
To Next Page
Loading...
