EasyManuals Logo

Epson 400 Series User Manual

Epson 400 Series
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
68 Notices
The lamp(s) in this product contain mercury. Please consult your state and local regulations
regarding disposal or recycling. Do not put in the trash.
Allow the lamp to cool for one hour before replacing it.
Unplug the projector during lightning storms or when not in use for extended periods.
Don’t place the projector or remote control on top of heat-producing equipment.
If you use the projector in a country other than where you purchased it, use the correct power cord
for that country.
Don’t stand on the projector or place heavy objects on it.
Don’t use the projector outside of the required temperature range of 41 to 95 °F (5 to
35 °C). Doing so may cause an unstable display and could lead to projector damage.
Don’t store the projector outside of the required temperature range of 14 to 140 °F
(–10 to 60 °C) or in direct sunlight for long periods of time. Doing so may cause damage to the
case.
WARNING: The cords included with this product contain chemicals, including lead,
known to the State of California to cause birth defects or other reproductive harm. Wash
hands after handling. (posted in accordance with Proposition 65 in Cal. Health & Safety
Code § 2549.5 et seq)
Remote Control Information
You can operate the projector by remote control via a line-of-sight infrared (IR) receiver at the front
and rear of the projector. The projector may not respond to remote control commands under the
following conditions:
There is an object between the remote control and the IR receiver on the projector.
Ambient light is too bright.
Certain types of fluorescent lighting are used.
Other equipment that emits infrared energy, such as a radiant room heater, is in the room.
If you experience problems, try the following:
The remote control’s batteries may be low on power; replace them.
Dim the ambient lighting and/or turn off any fluorescent lights.
Close any window coverings and/or move the projector out of direct sunlight.
Turn off other equipment that emits infrared energy.
PowerLite Cinema 400.book Page 68 Friday, July 7, 2006 2:24 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson 400 Series and is the answer not in the manual?

Epson 400 Series Specifications

General IconGeneral
Display Technology3LCD
Contrast Ratio15, 000:1
Zoom1.2x
Output PortsVGA
Noise Level37 dB (Normal Mode), 28 dB (ECO Mode)
ConnectivityUSB
Input PortsUSB, VGA

Related product manuals