c
Caution:
Once you remove an ink cartridge, it becomes unusable and
cannot be reinstalled even if ink remains.
1. Make sure the printer is on, then open the printer cover.
2. Hold down the
E
load/eject button for three seconds, the
print head moves to the replace position. The
P
power
light begins flashing.
3. Lift the appropriate ink cartridge clamp. Dispose of the
empty ink cartridge properly.
4. Remove the yellow tape seal from the new cartridge and
lower the cartridge into the cartridge holder.
5. Press the ink cartridge clamp down until it locks in place.
c
Caution:
Once you install the cartridges, do not open their clamps
again until you replace the ink cartridges. Otherwise, the
cartridges may become unusable.
6. Press the
E
load/eject button again. The printer moves the
print head back to its home position and charges ink in the
system.
c
Caution:
The
P
power light continues to flash while the printer
performs the ink charging operation. Never turn off the
printer while the
P
power light is flashing. Doing so can
result in incomplete charging of ink.
Note:
Even if you do not press the
E
load/eject button, the printer moves the
print head back to its home position about 60 seconds after you
replace the cartridge.
6
Troubleshooting
R
Hawaii2 Ref. Guide
Rev.b
A5 size Chapter 6
06-02-97 DR, pass 0
Troubleshooting
6-29
To Next Page
Loading...
