Using a printer stand
When using a printer stand, note the following:
❑
Use a stand that can support at least 11.0 kg (24.3 lb).
❑
Never use a stand that tilts the printer. The printer should
always be kept level.
Attaching the Paper Support
Insert the paper support into the slots at the rear of the printer
as shown below.
Note:
To print on transparencies, you need to reposition the paper support
as described in “Loading Transparencies” in Chapter 4.
!29-e1
L
Hawaii2 Ref. Guide
Rev.b
A5 size Chapter 2
06-02-97 DR, pass 0
2-4
Getting Started
To Next Page
Loading...
