Safety Instructions iii
Safety Instructions
Laser Printer Precautions
This printer uses laser technology. Follow the precautions below to ensure
safe, efficient operation.
❏ Unless specifically instructed in the
printer’s documentation, be careful
not to touch the fuser, which is
marked CAUTION HIGH
TEMPERATURE. If the printer has been
in use, the fuser may be very hot.
❏ Do not attempt to modify or take
the toner cartridge apart. It cannot
be refilled.
❏ Do not touch the toner and avoid all
toner contact with your eyes.
❏ If toner is spilled, use a broom and
dustpan or a damp cloth with soap and water to clean it up. Because
the fine particles can cause a fire or explosion if they come into
contact with a spark, do not use a vacuum cleaner.
❏ Do not dispose of used toner cartridge, photoconductor unit, or
waste toner collector in fire, as they can explode and cause injury.
Dispose of them according to local regulations.
Important Safety Instructions
Read all of the following instructions before operating your printer:
When choosing a place and power source for the printer
❏ Do not place the printer on an unstable surface.
❏ Do not put your printer where the cord will be stepped on.
❏ Slots and openings in the cabinet and the back or bottom are
provided for ventilation. Do not block or cover them. Do not put
the printer on a bed, sofa, rug, or other similar surface or in a built-in
installation unless proper ventilation is provided.
❏ The interface connector for this printer is Non-LPS (non-limited
power source).
❏ Avoid using outlets that other appliances are plugged into.
CAUTION
HIGH TEMPERATURE
To Next Page
Loading...
