❏ Make sure that you do not load paper beyond the limit tab.
a. limit tab
4. Raise the stopper.
Note:
❏ When you use the paper that is longer than A4 size, do not raise the stopper. To prevent printouts
from being stacked and pushed out of the output tray, every time the printer ejects a couple of the
printouts, remove them from the tray.
❏ Make sure that the locking lever for the pickup roller of the MP tray is in the locked position (up).
For the location of the locking lever and pickup roller, see “Inside the printer” on page 22.
If the locking lever is in the unlocked position (down), the pickup roll er may have come off. In that
case, reinstall the pickup roller. For details, see “Installing the pickup roller” on page 28.
Installing the pickup roller
If the pickup roller has come off, reinstall it as follows.
Epson AcuLaser M2300/M2310/M2400/M2410 Series User’s Guide
Printing Tasks 28
To Next Page
Loading...
