Item Explanation
Auto LF If you select Off, the printer does not send an automatic line-feed (LF) command with
each carriage-return (CR). If On is selected, a line-feed command is sent with each
carriage-return. Select On if your text lines overlap.
Settings (default in bold):
Off, On
Bit Image The printer is able to emulate the graphics densities set with the printer commands. If you
select Dark, the bit image density is high, and if you select Light, the bit image density is
low.
If you select BarCode, the printer converts bit images to bar codes by automatically filling
in any vertical gaps between dots. This produces unbroken vertical lines that can be read
by a bar code reader. This mode will reduce the size of the image being printed, and may
also cause some distortion when printing bit image graphics.
Settings (default in bold):
Dark, Light, BarCode
ZeroChar Specifies whether the printer prints a slashed or unslashed zero.
Settings (default in bold):
0, (or the zero character with a slash)
I239X Menu
Item Explanation
Font Selects the font.
Settings (default in bold):
Courier, Prestige, Gothic, Orator, Script, Presentor, Sans serif
Pitch Selects the pitch (the horizontal spacing) of the font in fixed pitch, measured in cpi
(characters per inch). You can also choose proportional spacing.
Settings (default in bold):
10cpi, 12cpi, 15cpi, 17cpi, 20cpi, 24cpi, Prop.
Code Page Selects the character tables. Character tables contain the characters and symbols used by
different languages. The printer prints text based on the selected character table.
Settings (default in bold):
437, 850, 858, 860, 863, 865
T.Margin Sets the distance from the top of the page to the baseline of the first printable line. The
distance is measured in inches. The smaller the value, the closer the printable line is to the
top.
Settings (default in bold):
0.30 ... 0.40 ... 1.50 inch in 0.05-inch increments
AL-M320DN/AL-M310DN/AL-M220DN User's Guide
Getting to Know Your Printer
36
To Next Page
Loading...
Need help?
General