Epson BrightLink 1485Fi - Two Screen Mirroring Sources; Screen Sharing Additional Functions

Details of User Operation Change (Version 1.50)
16
File type
(extension)
Details
.mp4/.mov (H.264,
H265)
• Resolution: 1920 × 1200 or less
• Size: 2 GB or less
• Movie Codec: H.264/MPEG-4 AVC or H.265/MPEG-H
HEVC
• Frame Rate: up to 30 fps
• Profile:
• H.264/MPEG-4 AVC: Baseline Profile, Main Profile, High
Profile
• H.265/MPEG-H HEVC: Main Profile
• Color Format: YUV420
• Single slice structure
• Audio Codec: MPEG-2 AAC-LC, MPEG-4 AAC-LC, or
LPCM
• Audio Channel: up to 2ch (channel 2)
• Audio Bit: 8 bits or 16 bits
• Audio Sampling Rate:
• MPEG-2 AAC-LC: 44.1 kHz, 48 kHz
• MPEG-4 AAC-LC: 44.1 kHz, 48 kHz
• LPCM: 11.025 kHz, 16 kHz, 22.05 kHz, 24 kHz, 32 kHz,
44.1 kHz, or 48 kHz
Two Screen Mirroring Sources
You can connect two devices that use Miracast technology at the same time.
The projector detects the input sources as Screen Mirroring1 and Screen
Mirroring2.
Previous Screen Mirroring Operation (Version 1.00)
You can connect only one device.
New Screen Mirroring Operation (Version 1.50)
You can connect up to two devices at the same time. To connect two devices,
set the Interrupt Connection setting to Off in the projector's Network menu.
s Network > Network Settings > Network Projection > Screen Mirroring
> Interrupt Connection
a
• When you split the screen into quarters and you want to select the
USB, Screen Mirroring1 and Screen Mirroring2 input sources, you
can only select up to two sources from them.
• When you use the PJLink input source command, you can use the
following numbers.
• Screen Mirroring1: 57
• Screen Mirroring2: 58
Screen Sharing Additional Functions
Some operations have changed when using the Screen Sharing feature among
projectors. You can share the screen even if the firmware version differs
among projectors, but you may not be able to share the screen depending on
the projector settings. It is recommended that you use the screen sharing
feature among projectors that have the same firmware version.
Previous Screen Sharing Operation (Version 1.00)
• For distributing projector, the Screen Type setting in the Installation menu
must be set to 16:9, 16:10, or 4:3.
• For receiving projector, the Screen Type must be the same as the
distributing projector.
• For receiving projector, you can only use the predefined drawing tools.
New Screen Sharing Operation (Version 1.50)
• For both distributing and receiving projectors, you can select any Screen
Type setting.
• For receiving projector, you can select the type of drawing tools using the
toolbar. (You cannot use the highlighter tool.)