Solving Multi-Projection Problems
28
e
Select the same settings for the other projector that creates one unified
image area.
a
If you cannot select 600 as the Blend Range setting, you can select a
lower setting. However, the black bands will appear on the side of the
projected image.
Solving Other Multi-Projection Problems
If you cannot project an image using the multi-projection feature, try the
following solutions.
• Change the Screen Type setting to 16:9. If you select other screen type
settings, the image may not be projected correctly.
• If you cannot use the interactive feature while using the multi-projection
feature, check the USB cable connection between projectors.
• Make sure the USB cable is securely connected to the USB-A1 or USB-A2
port of the first projector.
• When you set the USB-B2 setting to Off in the projector's Pen/Touch
menu, connect the USB cable to the USB-B1 port of the other projector.
• When you set the USB-B2 setting to one of the HDMI sources in the
projector's Pen/Touch menu, connect the USB cable to the USB-B2 port
of the other projector. The interactive feature is only available when you
select the input source specified in the USB-B2 setting.
s Pen/Touch > PC Interactivity > USB-B2
To Next Page
Loading...
