26
2. Use the M4 × 10 mm bolt with washer and spring washer to secure the interactive module.
3. Remove the USB port cover, and then connect the USB cable. Connect the other end of the USB
cable to the computer.
4. Attach the USB port cover, and then secure it using the M3 × 8 mm cross-head screw.
9. Connect the power cord and other cables to the projector
Connect any necessary cables such as the power cord, computer cable, HDMI cable, and USB cable to
the projector.
If you are planning to run the cables inside the wall, make sure you follow all local electrical codes. If
you are running the cables outside the wall, use a cable management system to keep the cables from
obstructing the image. An optional cable management system is available from Epson
(part # ELPCK01).
The USB cable connected from the projector to the computer is for USB Display
connectivity only.
q
If you are using both USB Display and interactive connectivity, Epson recommends
that you label the two USB cables accordingly.
Installation.book Page 26 Monday, February 13, 2012 4:23 PM
To Next Page
Loading...
