Epson BrightLink 425Wi - Attach the Cable Cover to the Projector; Attach the Wall Plate Cover

29
English
13. Attach the cable cover to the projector
Take up the cable slack, and then attach the cable cover and use a cross-head screwdriver to tighten
the screws (2) and secure the cable cover.
14. Attach the wall plate cover
Secure the wall plate cover with a hexagonal wrench (M4) and three M4 × 12 mm hexagon socket head
cap bolts.
Cable cover
Wall plate cover
M4 × 12 mm hexagon socket
head cap bolt (×3)
Wall plate cover
Only a specialist should remove or reinstall the projector for maintenance and repairs. Refer to
the projector User’s Guide for instructions on maintenance and repairs.
Caution
❏ Never loosen the bolts and nuts after installation. Regularly confirm that the screws have
not become loose. If you find any loose screws, tighten them firmly. Otherwise, the
projector or wall mount may fall and cause personal injury or property damage.
❏ Do not hang on the wall mount or hang a heavy object on the wall mount. If the projector
or wall mount falls, it could cause personal injury or property damage.
Warning
Installation.book Page 29 Monday, February 13, 2012 4:23 PM