307
Event ID code Cause and solution
0038 Wireless LAN system mismatch. Check the wireless LAN system for the mobile
device and the projector, and then reconnect.
0042
0041 Connection failed. Delete the recorded projector information on your computer and
try connecting again.
0043 The video format is not supported. Change the resolution of the mobile device, and
then reconnect. Or change the Adjust Image Quality setting for the projector, and
then reconnect.
0432 The network software did not start. Turn the projector off and then on again.
0435
0434 Unstable network communication. Check the network communication status, wait a
few moments, and try connecting to the network again.
0481
0482
0485
0433 Cannot display the transferred images. Restart the network software.
0484 Communication with computer was disconnected. Restart the network software.
0483 The network software quit unexpectedly. Check the network communication status,
then turn the projector off and then on again.
04FE
0479 A projector system error has occurred. Turn the projector off and then on again.
04FF
0891 Cannot find the SSID (network name). Make sure your computer and projector are
connected to your access point's current SSID.
0892 The WPA/WPA2 authentication type does not match. Make sure the wireless
network security settings are correct.
0893 The WEP/TKIP encryption type does not match. Make sure the wireless network
security settings are correct.
0894 Communication with unauthorized access point was disconnected. Contact your
network administrator.
0898 Failed to acquire DHCP address. Make sure the DHCP server is operating correctly.
If you are not using DHCP, turn off the DHCP setting in the Network menus.
To Next Page
Loading...
