345
Solutions When the Image Contains Static During Network Projection
If the projected image contains static during network projection, try the following solutions:
• Check for any obstacles between the access point, the computer, the mobile device, and the projector.
If necessary, change their positions to improve communication. Also, make sure that they are not too
far apart. Move them closer together and try to connect again.
• If the wireless connection is slow or your projected image contains noise, check for interference from
other equipment, such as a Bluetooth device or microwave. Move the interfering device farther away
or expand your wireless bandwidth.
• If the connection speed declines, reduce the number of connected devices.
Parent topic: Solving Network Problems
Solutions When You Cannot Connect Using Screen Mirroring
If you are unable to connect to the projector using Screen Mirroring , try the following solutions:
• Select On as the Screen Mirroring setting in the projector's Network menu.
• Make sure the Display Name setting does not contain a dash ("-") or it may not be displayed correctly
on the mobile device.
• Select Off as the Screen Mirroring setting, then select On again.
• Change the Operation Mode setting and connect again.
• Make sure no other mobile device is connected to the projector.
• Make sure the mobile device settings are correct and restart the device.
• Make sure Screen Mirroring is activated on the mobile device.
• Change the Channel setting according to the wireless LAN environment.
• You may not be able to connect immediately after disconnecting from the projector. Wait a while and
try connecting again.
• If you have previously connected to the projector using Screen Mirroring, the device may have saved
the previous connection information. Delete the saved information and connect to the projector from
the list of available devices.
Parent topic: Solving Network Problems
To Next Page
Loading...
