330
On/Standby
light
Status light Laser light Temp light Status and solution
Off Flashing blue Orange Off Laser has a problem.
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
• If the problem persists, unplug the
projector and contact Epson for
help.
Off Flashing blue Off Flashing
orange
A fan or sensor has a problem. Turn
the projector off, unplug it, and
contact Epson for help.
Off Flashing blue Flashing
orange
Off Internal projector error. Turn the
projector off, unplug it, and contact
Epson for help.
Flashing blue Varies Flashing
orange
Flashing
orange
Obstacle detection warning. A beep
sounds and you see an obstacle
warning. The projector turns off
automatically if you take no action.
• Remove any obstacles interfering
with the projection window.
• Clean the obstacle sensor.
If the problem persists, turn the
projector off, unplug it, and contact
Epson for help.
Off Flashing blue Orange Orange Obstacle detection error. Turn the
projector off, unplug it, and contact
Epson for help.
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
To Next Page
Loading...
