Epson C11CA31021NU Administrator's Guide

34
Preparation
Device name:
The name of the connected product can be set.
Publish Mode
• Mode: This displays the Publish Mode that was set. The Publish Mode can also be changed.
• Stacker 1: Select the type of disc that is used.
• Stacker 2: If set to External Output Mode, select the type of disc that is used.
• Stacker 3: If set to External Output Mode, select either one of the following options:
• Stop after each job (when set to Batch Mode)
If you check this check box, publishing process stops after each job. Taking out published discs (operating Stacker 2)
starts processing the next job.
Drive settings
• Drive used: Select the drive that will be used from the drives below.
• Number of write retries: The number of write retries after an error occurs during disc writing is selected from
zero to nine.
Item Description
Output stacker Select if you want to eject published discs to Stacker 3.
Do not use Select if you want to eject published discs to Stacker 4.
• If Standard Mode is selected, [Stacker 2] displays [Output Stacker].
• If Batch Mode is selected, [Stacker 2] displays the disc type selected for [Stacker 1].
• See “Changing the Publish Mode” on page 60 in this guide to change the Publish Mode.
• If you remove and install Stacker 2 in Batch Mode, the next job is started with Stacker 2 as
the output stacker even when published discs remain in it. If you check for [Stop after each
job], you can avoid such a trouble by taking out published discs after each job, when more
than one users are sharing this product.
Item Description
Use both
Both Drive 1 and Drive 2 are used to write the disc. Jobs will be efficiently processed by
using two drives. If trouble occurs on either drive and it cannot write data, the other
drive will be used automatically.
Use Drive 1 Only Use only Drive 1
Use Drive 2 Only Use only Drive 2

Epson C11CA31021NU Specifications

General

Brand	Epson
Model	C11CA31021NU
Category	Computer Hardware
Language	English