Epson C11CA31021NU Administrator's Guide

35
Preparation
Printer settings
• Show error mark on discs that experience errors
If you check this check box, an error mark will be printed on any disc with a write error. This is useful to identify the
disc which encountered the write error.
Notification settings
• Beep when a job is finished, or when the source stacker is empty
If you check this check box, the product produces a beep to notify you when a job (jobs) is finished or when you need
to replenish discs.
Also, select either one of the options to notify after each job is finished or after all jobs are finished.
4
Click [OK].
• Setting the number of write retries enables a job to be executed again without job
processing pausing even if an error occurs during writing. The error disc is output to the
output stacker.
• When a write error occurs based on a preset number of write retries, use of the drive is
automatically stopped, and [Drive operation paused DRV1/2] is displayed on the LCD. To
resume use of the stopped drive, make the setting at [Drive Settings].
• See “Disc writing problems” on page 78 in this guide for details on the causes and remedy
procedures for write errors.
The error mark will not be printed in the following cases.
• The job was cancelled in the EPSON Total Disc Monitor.
• Not enough ink was left to print the error mark
• Fatal error

Epson C11CA31021NU Specifications

General

Brand	Epson
Model	C11CA31021NU
Category	Computer Hardware
Language	English