Paper Handling
1-23
c
Caution:
Use overlapping multipart forms only under normal operating
conditions.
1. Make sure of the following:
❏
Your software settings keep the printing entirely within
the printable area. See “Printable area” on page A-24 for
more information.
❏ Tractor is selected as the paper source on the control
panel.
❏
The setting of the page length for tractor in the default
settings matches the page length of the form you use. See
“Changing default settings” on page 3-12 for more
information.
2. Turn on Overlapping Forms and Skip over perforation
settings in the default-setting mode.
Note:
When Overlapping Forms is turned on in the default-setting
mode, the printer automatically activates the auto paper thickness
function even though the paper-thickness lever may be set to another
position.
c
Caution:
❏
Printing on the edge of overlapping multipart forms can
damage the print head.
❏
Be sure to turn on Overlapping Forms and Skip
over perforation settings in the default-setting mode
when using this type of paper; otherwise your printer
may be damaged.
3. Follow the instructions in “Loading continuous paper with
the tractor” on page 1-9.
To Next Page
Loading...
