3-6
Control Panel
n=On, f=Flashing, o=Off
4. Make sure that the desired font and pitch are selected.
About Your Printer’s Default Settings
The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting from
the printer’s control panel using the default-setting mode.
For a detailed description of the settings you can change in the
default-setting mode, see “Understanding default settings” on
page 3-6. For instructions on changing the settings, see “Changing
default settings” on page 3-12.
Understanding default settings
This section describes the settings and options available in the
default-setting mode. These settings are shown in the following
table and explained in detail after the table.
To access and change a setting, see “Changing default settings”
on page 3-12.
on
USD
of
HSD
no
Draft
nn
Roman
nf
Sans Serif
To Next Page
Loading...
