Troubleshooting
4-13
Printing position problems
Wrong top-of-form position
The printer does not load the paper you want when you switch
between the cut-sheet feeder and the tractor.
Cause What to do
The paper source is not
selected correctly.
Select the proper paper source on the
control panel. (See “Buttons and
Lights” on page 3-1.)
Your printing appears too high or low on the page.
Cause What to do
The paper size setting in
your application software or
printer driver does not
match the size of the paper
you are using.
Check the paper size setting in your
application or printer driver.
The printer’s page length
setting for the tractor does
not match the size of the
continuous paper you are
using.
Change Page length for tractor
setting using the printer’s
default-setting mode. See “Changing
default settings” on page 3-12.
To Next Page
Loading...
