Control Panel
3-3
5 Paper Source button
Selects a paper source.
Tractor light
On when continuous paper is selected.
Manual/CSF light
On when single-sheet is selected.
6 LF/FF button
❏
Feeds paper line by line when pressed shortly.
❏
Ejects a single sheet or advances continuous paper
to the next top-of-form position when held down
for a few seconds.
7 Load/Eject button
❏
Loads a single sheet of paper.
❏
Ejects a single sheet of paper if a sheet is loaded.
❏
Loads continuous paper from the standby position.
❏
Feeds continuous paper backward to the standby
position if a sheet is loaded.
8 Micro Adjust
When you hold down the Pause button for three
seconds, the printer enters the Micro Adjust mode. In
this mode, you can adjust the top-of-form and tear-off
positions by pressing the LF/FFD and Load/EjectU
buttons. See “Using the Micro Adjust Function” on
page 1-37.
To Next Page
Loading...
