Control Panel
3-13
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. Turn on the printer while holding down the Font button.
The printer enters the default-setting mode and prints the
language selection instructions (one page).
3. Press the Font button until the Font and Pitch lights indicate
the language you want, as described in the language selection
instructions.
4. Press the Tear Off/Special Paper button to print the
default-setting mode instructions (two pages) in the language
you selected.
The printed instructions list the settings you can change,
describe how to change them, and show you how the control
panel lights help you make settings. Use these instructions to
change the printer’s default settings from the control panel.
Note:
The arrows in the instructions indicate the printer’s current
settings.
5. When you finish making settings, turn off the printer and exit
the default-setting mode.
Note:
You may exit the default-setting mode by turning off the printer at
any time. Any settings you have made remain in effect until you
change them again.
To Next Page
Loading...
