32
Chapter 2 Setup
2
Setting the DP-110
Connector installation screw
Inch-type hexagonal lock screws are installed in the connector for serial cable connection of DP-110.
If millimeter-type lock screws are needed, use the millimeter-type lock screws of the accessory.
Jumper setting
Set the jumpers as follows:
JP1 JP2 Description
1-2 1-2 For connecting both the TM printer and the DP-110. (Default setting)
2-3 2-3 Set this when using a standalone connection.
Notch (one or more lines)
inch-type
millimeter-type
Installation screw
To Next Page
Loading...
