35
Chapter 2 Setup
2
DP-210
Checking the accessories
Check the DP-210 parts.
Setting the DP-210
Connector installation screw
Inch-type hexagonal lock screws are installed in the connector for serial cable connection of DP-210.
If millimeter-type lock screws are needed, use the millimeter-type lock screws of the accessory.
Jumper setting
Set the jumpers as follows:
JP1 JP2 Description
1-2 1-2 For connecting both the TM printer and the DP-210. (Default setting)
2-3 2-3 Set this when using a standalone connection.
DP-210
Extension power cable
RS-232C connector installation screw
(millimeter type)
Support Extension support
Notch (one or more lines)
inch-type
millimeter-type
Installation screw
To Next Page
Loading...
