65
Chapter 2 Setup
2
3
Pass the cable for this product through the hole on fixing plate A and fix the cable at
the bottom as shown below.
4
Peel off the affixing tapes and secure it to the mounting position. When using screws
to attach it on the counter, use the screws to secure it to the mounting position.
5
Connect the cable to the TM printer. When the cable is long, put the excess part of the
cable in the support.
For the RS-232/USB model, the end of the connector of the unused cable should be
capped, and then bundled to be stored inside support.
To Next Page
Loading...
