Epson DS-560 - Manually Connecting to a Wi-Fi Router Using Epsonnet Config

4 Computer
5 Internet
6 Ethernet cable (used only for wired connection to the wireless router or access point)
Manually Connecting to a Wi-Fi Router Using EpsonNet Config
Setting Up Network Scanning
Parent topic: Wi-Fi Networking
Manually Connecting to a Wi-Fi Router Using EpsonNet Config
You can use EpsonNet Config to connect the scanner to an existing Wi-Fi network on a router or access
point.
Note: The scanner must be turned on and connected to your computer through a Direct Wi-Fi
connection before beginning this procedure.
1. Do one of the following to start EpsonNet Config:
• Windows 8.x: Navigate to the Apps screen and select EpsonNet Config.
• Windows (other versions): Click or Start, and select All Programs or Programs. Select
EpsonNet > EpsonNet Config > EpsonNet Config.
• OS X: Open the Applications folder, select Epson Software > EpsonNet > EpsonNet Config >
EpsonNet Config.
2. Select your scanner from the list and click Configuration.
3. Select Network Interface > Network > Basic (Wireless).
4. Select the following settings for your infrastructure connection:
• Communication mode: Select Infrastructure .
• SSID: Enter the SSID of the wireless router or access point.
• Security level: Select the wireless connection's security level.
• WEP Settings or WPA Settings: Enter the wireless connection's security key.
5. Click Transmit.
6. Open the Device menu and select Quit.
7. Turn off the scanner.
32