1. Set the connection mode switch on the scanner to AP mode.
2. Open the input tray and turn on the scanner.
3. Press and hold the Connect button for at least 3 seconds until the Status and ! error lights flash
alternately.
The scanner enters standby status for WPS connection for two minutes.
4. Press the WPS button on your computer or device, or enable the WPS feature.
When the Status light on the scanner stays on, the connection is established.
Parent topic: Direct Wi-Fi Mode Setup
Wi-Fi Protected Setup (WPS)
If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
scanner to the network using Wi-Fi Protected Setup (WPS).
37
To Next Page
Loading...
Need help?
General
