27
Searching by Specifying the IP Address and Projector Name (For "Advanced Connection Mode" only)
In the following explanations, unless otherwise noted, Windows screen
shots are used.
You see a similar screen even when using Macintosh.
A
Click "Manual search" on the EMP NS Connection
projector selection screen.
B
Enter the IP address or the projector name for the
projector you want to connect to, and click the "OK"
button.
The results of the search are shown on the EMP NS Connection
projector selection screen.
Assuming that the desired projector has been found by the search,
select that projector and then click the "Connect" button to
establish a connection.
When you will always be using that projector, save the search as a
profile, such that you do not have to specify the relevant details
every time you perform a search.s p.28
Procedure
q
When you use "Manual search" in "Quick Connection
Mode", you can specify the SSID. When there are a lot of
projectors you can narrow the search field by using SSID.
To Next Page
Loading...
Need help?
General
